A Level Physics Notes: Experimental Physics – Vector Force Diagrams
Apparatus:
3 x 100g mass sets, 1 x unknown mass (M), 1 x force board, protractor, chalk, string, scissors,
access to a top-pan balance.
Diagrams:
Procedure:
1. Set up the apparatus as shown in diagram A.
2. Place three 100g masses in each of the holders (of mass 100g) and adjust the holders’ positions until equilibrium is obtained.
Note: To check that equilibrium has been obtained; displace one of the holders slightly, the system should return to its original position if it was in equilibrium.
3. Using the chalk, note the positions of the strings on the blackboard.
4. Using the information from the blackboard , construct a
parallelogram of vectors diagram using the two outer masses as
forces
and
Remember
that a mass of 100g will have a weight of 0.98 N.
Your diagram should look like diagram B. It should be drawn to scale and have the same angles as on the blackboard set-up. It should also be as large as possible.
5. Measure the length of the diagonal and so calculate the value
of the resultant force
6. Compare the value of
obtained
from your diagram with the actual value of
E.g. if you have used a total mass of 400g for weight
should
be (4 x 0.98N) = 3.92N
7. Repeat steps 2 to 5 but with different masses in the holders (about three more combinations should be sufficient). Note you will probably have to keep the two outer weights similar to each other.
8. Finally replace the central mass holder with the unknown mass,
marked
Repeat
as before, and so calculate values for the weight and mass of
9. By considering the accuracy of your first four diagrams
estimate the uncertainties in your weight and mass values for
10. Use the top-pan balance to measure the mass of
and
compare it with your experimental value!